ARIETE 2712/1, Руководство пользователя

Страница: 36 / 90

- 34 -
EN
through remote control or touch screen, various cleaning modes can be selected:
1) AUTOMATIC cleaning:
Pressing the “CLEAN” button will start the
Robot cleaning the room automatically and
changing its route according to the obstruc-
tions on the floor, applying alternately:
- spiral movements
- linear perimeter movements
- linear diagonal movements
- automatic “SPot cleaning”: faster spiral
movements with greater suction when the
dust detection sensors find a particularly
dirty area. this function is interrupted
automatically when the area has been
cleaned or it can be stopped by pressing
the “CLEAN” button.
Important!
For the best cleaning results and to make sure that the Robot can cover the entire surface
of the room without leaving any area uncovered and in the shortest possible amount of
time, it is necessary to remove as many obstructions from the floor as possible.
Important!
To prevent the Robot from getting stuck, remove or lift any wires and power cords that
could become wrapped around the rotary brushes and cause items to fall from furnitu-
re or break or damage the Robot.
2) SPOT cleaning:
when it is required to clean a defined area, it is possible to select the Spot cleaning mode through the
“ ” button of the remote control or the “SPot” button on the Robot (for the operating modes, refer to
the instructions previously described).
3) Perimeter cleaning:
position the Robot next to an edge (e.g. wall, furniture) and press the “ ” button of the remote control.
the Robot will move along the whole perimeter.
Important!
If the Robot is positioned in the middle of the room, it could not detect and reach the
perimeter to cover.
the perimeter cleaning may be stopped through the “CLEAN” button, with which the “pause” and/or
“stand-by” modes are entered. the perimeter cleaning will stop automatically when the Robot detect
the Home base or once the battery is exhausted.
Home
Base