ARIETE 00C199420ARIT, Руководство пользователя

Страница: 14 / 16

EN
- 12 -
- Make sure the burner rings (C) lean perfectly against the white glazed base and are not
deformed.
- Connect the gas hose of the appliance with the nozzle (F) and fix it using the hose clamps at the
two ends, as shown in Fig. 1.
Important: the hose used must be approved (read all information contained in the warning
paragraph).
SWITCHING A BURNER ON
- Place the lighter flame near the burner to be switched on.
- Rotate the knob of the corresponding command counter-clockwise, as shown in Fig. 3.
WARNING:
Make sure the switching on is immediate, otherwise, turn immediately the knob off by turning
it clockwise to interrupt the gas supply and wait some minutes before trying again.
ALWAYS CLOSE THE GAS CYLINDER VALVE AFTER EVERY USE.
CLEANING AND MAINTENANCE
- Clean the appliance on a regular basis, especially after each use or if it has not been used for a
long period of time.
WARNING:
Allow the appliance to cool down before starting a new cleaning cycle.
Protect hands to prevent the risk of burns.
The gas cylinder must be kept outdoor in a well-ventilated area. Make sure there are no heat
sources close to the cylinder.
If the appliance has not been used for a long period of time, check for gas leaks and make
sure the burners are not clogged.
REPLACING THE CYLINDER
- Close the gas taps and the cylinder valve to allow the appliance to cool down before removing and
replacing the bottle.
- Do not replace the cylinder whilst the appliance is running, as it must be replaced in an environ-
ment free of open flames and outdoor.
- Do not smoke during this operation.
- Unscrew the pressure regulator from the cylinder tap;
- Before fixing the pressure regulator to the cylinder, replace the regulator gasket;
- Tighten properly the pressure regulator nut on the cylinder tap threading.