ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
2051182-INS-RA
•
PAGE 2
Step 1
Starting on the driver side, locate the three
mounting locations on the inside of the rocker
panel and underneath the vehicle.
NOTICE
Each bracket is specific to a mounting
location. Refer to the product photo
on page one for correct locations.
Step 4
Locate the rear mounting holes. Insert
a 3" x 1-1/2" spacer and a 1/2" carriage
bolt in the rear hole. Secure using
a 1/2" lock washer and flat washer.
Secure the front mounting bracket
using an M8 pull-through nut, lock
washer, flat washer and hex screw.
Snug the hardware,
but do not fully tighten.
Step 2
Locate the front mounting holes.
Secure the front mounting bracket
using an M8 pull-through nut, lock
washer, flat washer and hex screw.
Snug the hardware,
but do not fully tighten.
Step 3
Locate the middle mounting holes.
Remove any plugs if they are present.
Insert an M10 bolt plate into the rear mounting
hole. Secure using an M10 plastic bolt retainer,
flat washer, lock washer and hex nut.
Secure the front mounting bracket
using an M8 pull-through nut, lock
washer, flat washer and hex screw.
Snug the hardware,
but do not fully tighten.