ARIES INDUSTRIES CT1750, Руководство по эксплуатации и обслуживанию

Страница: 10 / 75

970262_A Aries Industries, Inc. ▪ (800) 234-7205 ▪ www.ariesindustries.com Page 9
Electric Wolverine
Section One
Operation and Maintenance
Truck System Interface
For first time users, use the Wolverine Quick Start Guide Manual (P/N 970245) for operation
setup. The quick start guide was created to help direct users on how to set up the Wolverine
system correctly via step by step instructions and pictures.
Cable Connections
The Electric Wolverine cutter tractor requires three electrical cables and three hose
connections for full functionality. These inner connect points are located between the reel
cable termination and the Wolverine cutter tractor tip-up assembly. The three inner connect
cables are a two pin cable (P/N 380112), a nineteen pin cable (P/N 380113), and an eight coil
cable (P/N 380380). The inner connect hoses are a small, blue air hose (P/N 381053), a small,
black water hose (P/N 381052), and a small, blue hose (P/N 381015). These inner connect
points must be securely fastened and undamaged for full functionality. The strain relief from
the reel termination needs to be connected to the clevises (P/N 380090) on the cutter tractor
tip-up to protect these inner connect points from damage before using the Electric Wolverine
cutter tractor.
If operations from the drive motors, the cutter tractor functions, or the cutter tractor camera
do not respond or respond faintly, troubleshoot the problem by using the inner connect cables
with the faceplate on the CC1750. The CC1750 control unit has a large nineteen pin socket and
a small two pin socket located on its faceplate. The nineteen pin socket is to test the cutter
tractor and cutter tractor camera (P/N 380353). The two pin socket is to test the drive motors
(Front P/N 380360 / Rear P/N 380350).
If the problems go away in testing the inner connect cables with the cutter tractor and camera
on the CC1750 control unit’s faceplate, the reel can be identified as the problem. See
Wolverine Electric Reel Cable for more information. If problems persist with the cutter tractor
or camera when using the inner connect cables with the faceplate, then the Electric Wolverine
reel and cable can be eliminated as the source of the issue.
Next, use the test cables to connect the cutter tractor and camera to the CC1750 faceplate. If
the problems do not go away when using the test cables with the cutter tractor or camera, then
the tractor and camera have been identified as the problem. Return the equipment to an Aries
facility for repair. See the Returning Equipment section. If the problems do go away when
using the test cables with the cutter tractor and camera, then the cable must be replaced. See
the Ordering Equipment section.