Ariens Pro 28 EFI CE, Руководство по обслуживанию, Страница: 39 / 84

EN – 38
TRACTION DRIVE CLUTCH CABLE
REPLACEMENT
Remove Traction Drive Clutch Cable
IMPORTANT:
Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove belt cover. See Figure 8.
See Figure 78.
4.
Remove hardware securing traction clutch cable
eyelet to traction idler arm and remove cable.
5. Loosen, but DO NOT remove hardware securing
cable pulley to pulley bracket. Remove cable from
pulley.
6. Place unit in service position and remove bottom
cover. See
Service Position
on page 7 and
Remove
Bottom Cover
on page 14.
7. Remove hardware securing upper traction clutch
cable to clutch lever and remove cable. See
Figure 79.
See Figure 80.
8.
Remove upper traction clutch cable from lower
traction clutch cable.
9. Loosen, but DO NOT remove hardware retaining
cable pulley to pulley bracket.
10. Remove lower traction drive clutch cable.
WARNING:
AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See
Draining Fuel System
on page 7.
Make sure unit is secure and will not tip.
Figure 78
1. Traction Idler Arm
2. Hairpin
3. Flat Steel Washer
4. Cable Pulley
5. Traction Drive Cable
1
4
5
3
2
Figure 79
Figure 80
1
2
3
1. Upper Traction Clutch Cable
2. Lower Traction Clutch Cable
3. Cable Pulley