EN - 11
Install Drive Pulley
See Figure 9.
1. Align holes of bagger sheave adapter
(item 7) with holes in spindle pulley and
position adapter on sheave. The cupped
surface in the adapter faces down.
2. Retain the adapter with two 5/16" x 3/4"
tapping screws (item 14).
3. Using a sturdy block of wood or other
suitable device, block blades from turning
and tighten tapping screws. Torque to
28.6 N•m (21 lb-ft).
See Figure 10.
4. Position V-pulley (item 8) on adapter and
retain with two 1/4” locking washers
(item 9) and two 1/4” x 1/2” hex bolts
(item 10).
5. Torque hex bolts to 9.5 N•m (7 lb-ft).
Install Belt Cover Support
Models 815048, 815049
1. Install 5/16" x 1 1/2" round head square
neck bolt (item 19) in belt cover bracket
(item 3) and secure with 5/16” hex jam
nut (item 12). Bolt is installed in tab
without trimmed corner. See Figure 11.
CAUTION:
Rotating one blade
will cause all blades to rotate.
Mower blades are sharp. Use
heavy gloves or cover blades
with tape.
Figure 8
Figure 9
Figure 10
Figure 11
