Ariens 939401, Руководство владельца/оператора, Страница: 16 / 30

EN - 16
CHECK CLUTCH CABLE
ADJUSTMENT
Make sure the attachment clutch and traction
drive clutch are adjusted to the range
specified in
Attachment Clutch/Brake
Adjustment on page 19 or Traction Drive
Clutch Adjustment on page 21.
CLEAN ENGINE
Refer to engine manual for detailed
instructions.
CHECK ENGINE OIL
The engine crankcase oil should be checked
every 5 hours of operation. Oil level MUST be
maintained in safe operating range on
dipstick at all times or engine damage will
result (See engine manual).
Park unit on a level surface. Refer to engine
manual for detailed instructions.
CHANGE ENGINE OIL
Refer to engine manual for detailed
instructions.
Run engine just prior to changing oil. Warm
oil will flow more freely and carry away more
contamination.
CHECK TIRE PRESSURE
Keep tires at pressure listed on the tire
sidewall. See
Check Tire Pressure on page 9.
CHECK AUGER GEARCASE
(Figure 10)
IMPORTANT: Proper oil level must be
maintained.
Gear cases are filled to the correct level at
the factory. Unless there is evidence of
leakage, no additional lubricant should be
required. Check oil level each season or
every 25 hours of operation.
IMPORTANT: Be sure unit is resting on a
level surface before checking lubricant levels.
To ensure adequate lubricant level:
1. Remove oil fill plug and seal washer
(Figure 10). Lubricant must be 1.63 in. –
1.88 in. (4.14 cm – 4.78 cm) from the flat
surface of the gear case cover.
IMPORTANT: DO NOT remove the gear case
cover.
2. Check oil level with suitable dipstick
device. Add lubricant if required.
NOTE: Inspect seal washer for wear or
rubber deterioration and replace as needed.
IMPORTANT: Use only Ariens L3 synthetic
severe duty gear lube (Part Number
00068800). Use of other lubricants will void
unit warranty.
3. Reinstall oil fill plug and seal washer to
80 lbf-in. (9 N•m).
IMPORTANT: DO NOT OVER-TORQUE!
Note that measurements are in pound force
inches (lbf-in) and NOT pound force
foot (lbf-ft).
IMPORTANT: Be sure to install seal washer
with rubber side down (Figure 10).
IMPORTANT: Improper torquing, omission of
seal washer, or incorrect installation of seal
washer will void unit warranty.
GENERAL LUBRICATION
IMPORTANT: Wipe each fitting clean before
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to
get on the belts.
NOTE: Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS on page 24 .
Unit should be lubricated at beginning of
season or every 25 operating hours.
Figure 10
1
1. Auger Gearcase
2. Oil Fill Plug
3. Seal Washer
2
3