Ariens 926078, Руководство оператора

Страница: 18 / 34

EN - 16
IMPORTANT: Wipe each fitting clean before
and after lubrication.
Remove Bottom Cover
See Figure 20.
1. Place unit in service position (see
Figure 18).
2. Remove three top-lock flange nuts
retaining height-adjuster plate to height-
adjuster bracket.
3. Remove height-adjuster plate and three
spacers on the round head square neck
bolts. The height-adjuster stop will be
attached to the rear axle.
4. Slide height-adjuster stop to the right and
rotate it away from frame.
5. Remove six bolts retaining bottom cover
and remove cover. Rotate track carriage
as needed to remove cover.
Lubricate Unit
Use the following key for all lubrication
procedures.
1. Lubricate as shown in Figures 21 and 22.
Refer to the service manual for track
wheel removal instructions.
2. Reinstall bottom cover and return unit to
operating position.
CAUTION: AVOID INJURY.The
track carriage will rotate freely
without the height-adjuster
bracket. Keep fingers and hands
away from pinch points.
Figure 20
1. Top-lock Flange Nut
2. Height Adjuster Plate
3. Height Adjuster Stop
4. Bottom Cover
5. Rear Axle
2
5
4
1
3
*
= Lubricate on Both Sides
Grease Oil
Figure 21
Figure 22