Ariens 911173, Руководство пользователя

Страница: 20 / 30

EN - 20
SERVICE POSITION
Put unit into service position for easy access
to bottom of deck.
1. Place unit on a flat, level surface.
2. Disconnect spark plug wire.
3. Remove fuel cap.
4. Place a piece of plastic bag over the
opening and tighten cap securely.
5. Remove discharge chute if installed.
6. Tip unit onto right side.
Make sure unit is secure and will not tip
over.
IMPORTANT:
Remove plastic from fuel cap
after unit is upright and service is complete.
HANDLEBAR HEIGHT
(911173)
To adjust (Figure 14):
1. Remove hardware from lower handlebar
mounting hole.
2. Rotate the handlebar to the desired
position and align the mounting holes
with the holes in the handlebar upright.
3. Secure handlebar with hardware
removed in step 1.
NOTICE: To fold handlebar flat for storage,
remove the hardware from the lower
handlebar mounting holes, rotate the
handlebar forward, and then tighten the
hardware in the holes on the handlebar.
HANDLEBAR HEIGHT
(
911175, 179
)
To adjust (Figure 15):
1. Push the control handle forward slightly
and rotate handlebar to the desired
position.
To store (Figure 16):
NOTICE: To reposition handlebar for storage,
push the control handle forward slightly and
rotate the handlebar into vertical position.
WARNING: DO NOT operate unit with
handlebar in storage position. Handlebar
must be in operating position before using.
SERVICE AND ADJUSTMENTS
CAUTION:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.
CAUTION:
Avoid fuel spills. Follow
steps below to help prevent fuel
spills. If fuel leaks into air cleaner,
replace air cleaner. ALWAYS
clean up any spilled fuel.
Figure 14
1. Handlebar
2. Mounting Hardware
2
1
Figure 15
1. Control Handle
1