Ariens 891003, Руководство владельца/оператора

Страница: 14 / 32

14
5. Install the two coupling nuts to deck with two
0.31-18 x .75 round head square neck bolts with
Loctite patch as shown in Figure 13.
6. Install the belt guard supplied in the blower mount
kit with the clamping knob and flat washer and two
0.31-18 x 0.62 SEMS bolts.
INSTALL HOSE
1. Install 7 x 63 hose (item 18) on blower
assembly (item 19) and on the inlet adapter. Make
sure the thumb latch on the inlet adapter captures
one rib on the hose.
NOTE: Trim hose length as needed. The hose must fit in
thumb latch on the bagger cover assembly (item 9) and
over the hose adapter on the blower assembly (item 19).
Figure 12
Note belt twist here.
Route tapered
section of the
belt here.
Route flat "back"
side of belt here.
52-inch deck shown.
Other decks similar.
Figure 13
Clamping
Knob and
Flat Washer
SEMS Bolts
Coupling
Nuts
Round Head
Square Neck
Bolts
CAUTION: Deflected material may cause injury.
ALWAYS operate mower with bagger cover
closed and secured, blower assembly fastened
securely, or with chute deflector in operating
position.
Figure 14
Make sure the latch captures
one rib on the hose.
18
19