Ariens 136cc Series, Руководство по эксплуатации

Страница: 7 / 35

ARIENS AX Snow Engine Manual
4
1 2
4
10
10a
5
6
3
7
8
9
Controls & Features
CONTROLS
1. Choke Control Knob
The Choke Control Knob opens and closes the choke valve in the carburetor.
The “START” position enriches the fuel mixture which allows easier starting
a cold engine. The “RUN” position provides the correct fuel mixture once
engine warms up. Never try to shut the engine down using the Choke Control
Knob.
2. Idle-Down Control Ring (if equipped) (not shown)
The Idle-Down Control Ring sets engine speed from high-speed to low-
speed. Rotate the ring clockwise, “RUN” position for high-speed. This control
MUST be set in the “RUN” position for starting a cold engine. By rotating the
ring counterclockwise, “IDLE” position, will allow your engine to run at low-
speed. DO NOT OPERATE EQUIPMENT IN THE IDLE POSITION. Note: the
idle-down control is intended to be either in “RUN” or “IDLE” positions only.
3. Keyed Run/Stop Switch
The Keyed Run/Stop Switch enables and disables the ignition system. Turn
the engine’s key switch to the RUN position to enable the engine to start and
run. Turn the Engine’s key switch to the STOP position to stop the engine.
Remove the key for SAFETY to prevent non-supervised operation.
4. Fuel Control Knob
The Fuel Control Knob opens and closes the passage between the fuel tank
and carburetor. The Fuel Control Knob must be in the “ON” position for the
engine to run. When the engine is not in use, be sure to turn the Fuel Control
Knob to the “OFF” position.
5. Primer Bulb
The Primer Bulb system is designed to enrichen the fuel mixture for starting a
cold engine. DO NOT over prime the fuel system. To properly use the Primer
Bulb system, depress Primer Bulb 3 times maximum when starting a cold
engine. Do not use Primer Bulb system when attempting to start a warm
engine.
6. Oversized Recoil Handle
The engine is started by pulling the Recoil Handle. Always grip
firmly and have your body positioned properly when pulling.
When starting the engine:
· Slowly pull Recoil Handle until resistance is felt.
· Then pull firmly the full length of the rope to start engine.
· Never wrap thumb around Recoil Handle in the event of
engine kick-back.
7. Oversized Gas Cap
Allows for easy opening and closing for more
efficient refueling.
8. Electric Start (if equipped)
Used to start the engine with 120VAC extension cord.
Always use correct size extension cord to prevent
electric starter damage.
9. High Oil Fill Tube
Allows convenient location for adding oil during the life
of the engine. Check oil level with lower oil fill plug per
owner’s manual instructions.
10. Oil Drain
The oil drain can be located on either side and on some
models extend out below the recoil housing.