Ariel Whirlpool BT series, Руководство пользователя

Страница: 7 / 9

User manual whirlpool D-series with Bluetooth User manual whirlpool D-series with Bluetooth
Once a device is connected to the system it will auto-detect when Bluetooth function activated on the control panel. If there is more
than one device paired to the system, the system will choose one of them automatically. If the system connects to wrong device,
deactivate the Bluetooth function by pressing the Music button then press and hold the Music button for 3 seconds and the Bluetooth
symbol will start flash and the system is in search mode.
Turn off and on the Bluetooth function or open Bluetooth function on the device for connection and pairing with the “Whirlpool”.
Sound volume can adjust using the parameter setting buttons set into 9 different volume levels.
Air pump:
Press the air pump button to activate the pump.
Whether the water is above or below the water sensor, if you press the air pump button, the air pump will start and blow warm air
through the bottom jets. The air pump will automatically shut down after 20 minutes. If the water level changes from above to below the
sensor, the air pump will stop automatically. The icon of the air pump will start to flash. In order to activate the air pump again, press the
air pump button. If the water pump and air pump both work at the same time but with a different start time, both pumps will automatically
turn off after 20 minutes.
To stop the air pump, press the air pump button.
When the water no longer detected on the water level sensor, the air pump will run automatically after 20 minutes for a preset
time of 1 minute to dry the air jets.
And it will do it in these three different scenarios:
1. Water is no longer detected by the water level sensor with system still turned on
2. Water is no longer detected by the water level sensor and then the system is turned off
3. System is turned off and after that the water no longer detected by the water level sensor.
After installation:
1. Before starting up the product for the 1
st
time you have to go over all connections to control that they are well
connected. Recommended control points are water fittings and pipes on the faucet to the various functions.
2. Before starting up the product for the 1
st
time you have to check if all electrical wires are connected correctly.
3. After installation check that the whirlpool is clean. We recommend to clean the whirlpool first before you add water to it. Any
dirt can clog the pipes and massage jets. If the bath is clean, close the drain of the tub and fill the tub with water up to the sensor.
The sensor for this is placed just above the level of the highest jets. If the water is below the sensor, the pump will not work for safety
reasons.
4. Switch the system on and operate for a minimum period of 10 min. Without draining down, switch the whirlpool system off
and after a minimum period of 10 min check all pipework, joints and connections for possible leaks. After any necessary adjustment to
ensure the integrity of the installation or the replacement of any faulty elements, repeat the procedure.
5. You must ensure that the product works as expected. Test all functions of the product to immediately check and correct any
errors. After testing, put the bath in place and seal the wall joints with acid-free plumbing kit. Let it harden sufficiently.
Important note:
In general, the use of strong bath oils in whirlpools is against advise. Oil remains can stick on the inside of the hose system and can cause
troubles in due time. If you do want these kind of products, use oils specific for whirlpools.
The display:
Power supply
Colour changing lights
Channel memory
Air pump
Constant temperature
Brightness function
Parameter setting
Water pump
Music
Parameter setting up
Parameter setting down
Page 7 / 9 Page 4 / 9