34
LED Indicators:
Power and Ready LEDs blink alternately
Power LED
Ready LED
ON
OFF
OFF
ON
Possible Problems
Solutions
Remarks
Ribbon out
Install a new ribbon roll Set “Direct Thermal”
printing by driver or
commands if no ribbon is
required.
LED Indicators:
Only the Power LED blinks
Power LED
Ready LED
ON
ON
OFF
ON
Possible Problems
Solutions
Remarks
Serial IO error
Check serial baud rate at
both of your system and
the printer.
For serial interface only
Cutter has failed, or
there is paper jam
inside the cutter.
Check the cutter or
recover paper jam.
Only applicable when
cutter mode to cutter
mode.
Other possible
hardware errors.
Contact the reseller for
further service.
www.meteorbarcode.it - [email protected]
