8
Assembly Instructions
Step
10
b:
Fit the back
a:
Square up the unit by
making sure that
measurement
x to x
equals y to y.
Place the small back
and large back down
onto the unit as shown.
Make sure that
the 2 backs are
pushed up tight
against each
other and that
they meet over
the back edge of
the upright.
b:
Nail around
the outside edges
of the 2 backs.
Note:
Do not nail where
the backs meet. Nails
should be spaced about
150mm apart.
10
11
B
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
y
y
x
x
B
Warning:
The
unit is heavy.
Lift with care.
10
11
Step
11
Secure the backs
Tap the nail screws
through the back holders
. and down between
the backs and
into the back edge
of the divider.
Keep tapping the
nail screws in
until the back
holders dig
into the small
and large back.
Stand the unit up for
the next step.
K
J
10
11
K
J
10
11
K
J
+
x 5
Note:
Do not
nail where the
backs meet.
K
J
J
Note:
These can
also be round
