Assembly Instructions
9
Step
12
Make sure that the plastic
sleeve is fully pushed
onto the shelf stud.
L
Warning:
The
unit is heavy.
Lift with care.
11
10
F
H
F
Fit the back panels
a:
Square up the unit by
making sure that
measurement
x to x
equals y to y.
b:
Place the back
and foldy back , unit
colour facing down, onto
the unit as shown.
Make sure that the 2
backs are pushed up
tight against each other
and that they meet in the
centre of the upright
panel’s edge.
Nail around the
outside edges of the 2
backs.
Note:
Do not nail where
the 2 backs meet. Nails
should be spaced about
150mm apart.
c:
Using 9 screws ,
screw down between the
2 backs and into the
upright panel’s back
edge.
Note:
You will need to
keep 1 screw to use
in the final step.
Stand the unit up for
the next step.
3
3
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
y
y
y
x
x
F
c:
11
10
F
x 9
H
b:
10
11
