y
y
y
y
x
x
x
x
Assembly Instructions
11
Step
16
Fit the 2 back panels
a:
Square up the unit by
making sure that
measurement
x:x equals
y:y.
Place the small back
and large back ,
coloured surface facing
down, onto the unit as
shown.
Make sure that the 2
backs are pushed up
tight against each other
and that they meet in the
centre of the divider’s
back edge.
b:
Nail around the
outside edges of the 2
backs.
Note:
Do not nail where
the 2 backs meet.
c:
Push the nail screws
. through the back
holders and tap them
down between the small
back and large back
. and into the back
edge of the divider .
Keep tapping the nail
screws in until the
back holders dig into
the small and large back.
15
16
J
H
I
15
16
8
H
I
Note:
If ever you need to take
the backs off to dismantle the
unit, the nail screws can be
taken out using a screwdriver.
H
I
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
Note:
These can
also be round
I
H
+
c:
H
I
15
16
I
b:
J
15
16
