1
Safety and Care Advice
Important
- Please read these instructions fully before starting assembly
Warnings
Care and maintenance
• Because of the size of this unit,
it is recommended to assemble it
in the room intended for use.
• Do not discard any of the
packaging until you have
checked that you have all the
parts and the pack of fittings.
• Discard all extra fittings and
keep fittings out of reach of
children.
• Assemble this product on a flat
surface.
• Assemble all
parts loosely
before tightening any bolts.
• At least 2 people are required
to assemble this product.
• Unit weight: 54kgs.
• Re
tain Assembly Instructions
for future reference.
• We do not
recommend the
use of power
drill/drivers
for
inserting screws
,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
•
READ CAREFULLY - RETAIN
FOR FUTURE REFERENCE
• Regularly check and ensure
that all bolts and fittings are
tightened properly.
• Always use the ladder for
entering and leaving the upper
bunk.
• The recommended mattress
size is L1900 x W910 mm.
• Ensure thickness of mattress
does not exceed 220 mm.
• Refrain from using the bunk
bed if any structural part is
broken or missing.
• Please advise your children to
only enter and leave the upper
bunk by using the ladder.
• Please prohibit more that one
person on the upper bunk.
• Please prohibit children from
jumping on the upper and lower
beds.
•
WARNING:
Do not allow
children under 6 years of age to
use the upper bunk due to risk
of injury and falls.
•
STRANGULATION HAZARD
-
Never attach or hang items such
as ropes, strings, cords,
harnesses and belts to any part
of the bunk bed.
•
WARNING:
Children can
become trapped between the
bed and the wall. To avoid risk
of serious injury the distance
between the top safety barrier
and the wall shall not exceed 75
mm or shall be more than 230
mm.
• Folding and unfolding the futon
should only be carried out under
adult supervision.
•
THIS BED COMPLIES WITH
EN747-1:2012 / EN747-2:2012
• Please clean the unit surface
using either damp (not wet)
cloth and a mild domestic soap
solution or by using an
appropriate polish.
• Do not use any abrasive
materials when cleaning.
• From time to time check that
there are no loose bolts on this
unit.
Note:
if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
