argon audio 7450A Скачать руководство пользователя страница 10

 

                                                                                                                                             

 

 

w w w . a r g o n a u d i o . c o m                    1 0  

7460

/

50A 

 
Specifications

General 7460A/7450A 

Type: 2Way Loader Speaker, 2 Drivers, reflex type cabinet 
Inputs: Digital USB3.0 audio,1xmini-jack 3,5 mm stereo, L/R 
RCA stereo input, L/R ¼”TRS phone plug 
Output: SUB-OUT Sub output level 1.0V 
Main voltage: 220-240V, 50/60Hz 
Amplifier type: Dual Class AB 
Distortion: @4ohm/1-50W <0.05% 
Input sensitivity: 1000mV (RCA) 500mV (3.5mm mini-jack), 
1000mV TRS 
 

Specific 7460A 

Tweeter: 1” Horn loaded design 
Woofer: 6” High Power Kevlar Woofer Speaker 
Frequency Response: (-3db): 25Hz-20KHz 
Output Power: 2X65W (RMS 20-20.000 4ohm) 2X90W 1khz 
Weight: 16kg 
 

Specific 7450A 

Tweeter: 1” Horn loaded design 
Woofer: 5” High Power Kevlar Woofer Speaker 
Frequency Response: (-3db): 30Hz-20KHz 
Output Power: 2X50W (RMS 20-20.000 4ohm) 2X75W 1khz 
Weight: 12kg 

 
 
 
 
 
 

 
Basic Troubleshooting 

If the LED does not light up, check... 

that the AC power cord is firmly plugged into the rear panel 
and wall outlet. 
to make sure the speaker rear panel power switch is ON. 
that the speaker is getting power from the wall outlet. 
that the rear panel voltage selector is matched to the 
operating voltage. 
the fuse in the AC IN on the rear panel. If the fuse needs to 
be replaced it is extremely important to replace only with 
same fuse type and value. 

If no sound output, check... 

that the speaker is turned on (blue LED illuminated) 
to make sure the right speaker is connected correctly to the 
left. 
that the volume on the speaker back  panel is not all the 
way down. 
the volume level on the iPod or other audio source. 

If bass output is low, check... 

speaker wire polarity (verify that wires are going to same 
terminals on both speakers) 
that the speaker placement is not too close to a wall or 
other obstruction. 
that the bass ports on the rear panels are not blocked by a 
rodent or jelly sandwich. 

If no output from right speaker, check... 

that the speaker wire is properly connected from the left to 
right. 
Check by removing the speaker wire from both terminals on 
each speaker and reconnecting.

 

 

Содержание 7450A











Отзывы: