10
NITROGEN PRO 230A: 4. Stem/Handlebar Installation
2. Place the elastic cover on the stem and the
spacer with the Argon 18 logo facing up.
3. Place the handlebar upside down on a clean
rag.
4. With the correct spacer and stem length
using a torque wrench, a ratchet extension,
and a 6mm bit thread the bolt and spacer up
to 40Nm.
5. For easier handling and to prevent damage
to the handlebar we recommend holding it
down firmly while tightening.
40Nm
IMPORTANT:
If the appropriate torque (40Nm)
is not reached and if Loctite is not
applied the handlebar could loosen.
Argon 18 cannot be held accountable
if this is not measured.
