19
V 10/16
AUTO-STOP
: automatic shut-down of the unit if the tank is full or incorrectly positioned, or when the room humidity is 5%
below the set humidity.
AUTO RESTART
: the dehumidifier starts up again after a power failure.
MEMORY FUNCTION:
the dehumidifier maintains its settings during a power failure.
CHILD LOCK
: to disable the buttons, press the Mode and Timer BUTTONS for 1 second: the LC symbol will appear on
the display. To reactivate the control panel, press the Mode and Timer buttons again for 1 second.
DEFROST:
The dehumidifier can function properly with a room temperature
b 5 °C and + 35 °C
. When the
dehumidifier works with a low room temperature, the surface of the evaporator may accumulate ice, which could make
the dehumidifier less effective.
When this happens, the dehumidifier goes into defrost mode. The compressor stops, but the fan continues running.
We recommend not using the dehumidifier in room temperatures lower than 5 °C.
CLEANING AND MAINTENANCE
MAINTENANCE OF THE HUMIDIFIER’S EXTERIOR SURFACE
Warning
Always pull the dehumidifier's plug out of the power socket before cleaning it, to prevent electric shock and
malfunction.
Warning
Do not wet the appliance or immerse it in water, otherwise electric shocks may occur.
Use a damp and soft cloth to clean the exterior surface of the dehumidifier.
Do not use solvents, petrol, xylene, talcum powder or brushes to clean the unit: these may damage the surface
or colour of the casing.
CLEANING THE WATER TANK
We recommend removing the tank once every few weeks to prevent mould and bacteria from forming. Fill the tank with
clean water a small amount of detergent; swill the water around in it, then it out and rinse it thoroughly.
PLATINUM 21
1. Remove the tank and pour out any remaining water.
2. Press the 4 tabs around on top (1). Lift the cover (2)
3. After cleaning, replace the cover and check that the float is correctly positioned.
4. The side with the foam must fit together perfectly with the cover. Do not remove the foam from the float.
PLATINUM 41
1. Remove the tank and pour out any remaining water.
2. Turn the handle (3) to lift it and remove it from the cover holes (5).
3. Open the 4 hooks on the cover (4) and lift the cover (6).
4. After cleaning, replace the cover and check that the float is correctly positioned.
5. The side with the foam must fit together perfectly with the cover. Do not remove the foam from the float.
(1)
(2)
(3)
(4)
(5)
(6)