17
V 10/16
REMOVING THE CONDENSATION - FILLING THE INNER TANK
The water extracted from the air can be collected in the rear tank.
When the tank is full, the unit turns off. The FULL TANK led turns on and the unit beeps for about 10 seconds.
To switch off the appliance, press the ON/OFF button and wait a few seconds.
1. Carefully remove the tank using both hands and following the direction of the arrow.
2. Empty the tank.
3. Reposition the tank following the direction of the arrow.
N.B.
Do not use the drain hose when you are collecting condensation in the tank, otherwise water can leak out of the hose.
CONTINUOUS CONDENSATION DRAINAGE
You can fit a PVC hose with an internal diameter of 14 mm and length of 1.3-1.5m(not included) to drain the tank
continuously.
Turn off the appliance and remove the plug before connecting the hose.
Open the hatch covering the drain
hole on the side of the appliance.
To remove the hole cover, turn it in
the direction of the arrow (1).
Remove the protective cover (2) and
screw the drainage hose adapter (3)
(included ) onto the drainage hole.
Connect a PVC hose (not included) to
the continuous drainage hole.
Connect the hose to a continuous
drainage channel.
The height of the drainage hose must not exceed that of the hole: do not block the drainage hose exit.
Occasionally check that the adapter and drainage hose are tightly connected and not damaged or blocked.
(1)
(2)
(3)
(1)
(2)
(3)