Argo All 6X6, Руководство по обслуживанию

Страница: 57 / 297

ES-5
Electrical System Argo Service Manual
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
The battery must be out of the vehicle and placed on a
level surface. Remove electrolyte container from the
plastic storage bag. Remove the strip of caps. Put the strip
aside as you will use it later to seal the battery cells . For
battery filling use only the dedicated acid container that
comes with the battery as it contains the proper amount
of electrolyte for that specific battery. This is important
to service life and battery performance. Do not pierce, or
otherwise open the foil seals on the electrolyte container.
Do not attempt to separate the individual electrolyte
containers.
Place the electrolyte container with the foil seals facing down into the cell filler
ports on the battery. Hold the container level and push down to break the foil seals.
Electrolyte will start to flow into the battery and air bubbles will be seen inside the
container. Do not tilt the electrolyte container.
Check the electrolyte flow. Keep the container in place for 20 minutes or longer until it
empties completely. If no air bubbles are coming up from the filler ports, or if container
cells haven’t emptied completely after 20 minutes, tap the container and/or battery case
a few times to cause the electrolyte to flow into the battery.
Do not remove the acid container from the battery until it is
completely empty. The battery requires all of the electrolyte
from the container for proper operation.
Bubbles will appear as the electrolyte container fills the
battery indicating the flow of battery acid. Tap the container
periodically to keep the electrolyte flowing until the container
is completely empty. Never puncture the top of the acid
container to speed up the filling process.
ES INDEX MAIN INDEX