1. INSPECT ALL PARTS PRIOR TO INSTALLATION FOR
SUITABILITY AND/ OR DEFECTS
2. ANY SUSPECTED DEFECT SHOULD BE REPORTED AS
SOON AS POSSIBLE
3. SHOULD ANY PRODUCT BE INSTALLED DESPITE A FAULT
HAVING BEEN FOUND AND REPORTED, ARGENT WILL
NOT ACCEPT LIABILITY FOR THE COST OF LABOUR TO
REMOVE AND INSTALL ANY REPLACEMENT PRODUCT/S
BASIN MIXERS
NOTES PRIOR TO INSTALLATION
1. Please ensure pipework is clear of debris by flushing
lines prior to installation.
2. We recommend hot and cold water isolation stops are
used – not included in supply.
NOTES FOR INSTALLATION
1. Inlet pressure range 100 – 500kpa
2. Maximum hot water temperature 60 C
3. AS/NZS 3500 requires 500 kPa maximum operating
pressure at any outlet within a building
4. Hot & Cold inlets should have equalised water
pressures.
PRESSURE AND TEMPERATURE REQUIREMENTS
21008
ASNZ 3718
• Where the mixer is going into a stone or
laminate top, cut a 35mm ø hole.
STEP 1
• Install the allthread screw into the
bottom of the basin mixer.
• Install basin mixer sealing O ring &
flange(if supplied)
STEP 2
Please direct any
feedback for this product
to Customer Central:
support@customer-
central.com.au or call
1300 364 748
Eura Basin Mixers
Care & Installation Guide
Technical Hotline
Customer Central
1800 356 717
1300 364 748
EURA
