Page 2
CONTROL FUNCTIONS:
The buttons on the receiver perform the functions as detailed below:
MOUNTING INSTRUCTIONS:
The ARG 2.4GHz Receiver is a universal unit designed to be compatible with most makes and models of cardio
equipment. To mount the Receiver:
1. Determine the appropriate location to mount the receiver to the cardio equipment. Take note the range of
motion of the components of machine and make sure the placement of the receiver and its cabling will not
interfere with operation of the machine or any safety features.
2. Slide the cable ties through the appropriate holes in the mounting cleat on the underside of the receiver.
(Top to bottom if you are mounting it to a horizontal bar or side to side if you are mounting to a vertical bar.)
3. Wrap and thread the cable ties around the bar on the cardio machine at the pre-determined location. Pull
the ties tightly around the bar so the receiver does not move or rotate. Be careful not to over-tighten the ties
to avoid cracking the mounting cleat or receiver case. Trim off the excess ends of the cable ties.
4. Connect the power cable to the receiver. The receiver can be powered by either a C-SAFE power outlet on
the cardio machine or an A/C power converter that is plugged into the wall/floor. (Power adapters and
cables are not included and must be ordered separately.) If you are using a C-SAFE connection: connect
one end of the Cat-5 cable to the C-SAFE port on the cardio machine. (Check with the equipment
manufacturer to make sure the machine has this feature and for location of the outlet.) The other end of the
cable connects to the RJ45 receptacle on the back of the receiver. If you are using an A/C power supply:
locate a standard 110V outlet and plug the 12V A/C adapter side into the outlet and the RJ45 plug into the
receptacle on the back of the receiver. Make sure to route the cord for either option appropriately to avoid
interference with any of the functions or safety features of the cardio machine.
