AV818X/AV836X Tilt Adjustment Instruction B
INSTRUCTION B:
1.
Make sure that bracket lies on the same side as an open threaded hole next to
shaft holders. This is your “standard” installed position (see Pic. 3, holes
circled)
2.
Remove top fabric sheet.
A.
Using 1/16” hex L-key undo 5 screws on the top of the bracket to release
upper end of the fabric. Set small bracket aside
B.
Remove 2 screws to release middle section of the fabric.
C.
Remove 5 screws from the bottom arc, set arc aside and remove fabric sheet.
3.
Note the position of shaft holders on the main plate in relationship to open
threaded hole next to shaft holders.
4.
Using enclosed 1/16” hex L-key undo set screws on the top of the “second
floor” shaft holders, but don’t completely remove set screws from holders.
5.
Using enclosed 5/64” hex L-key remove 4 screws from shaft holders.
6.
Switch shaft holders so the ones with set screws will be on the top (3
rd
floor)
Make sure that:
A.
Shaft holders are on the same positions as they were before modification
(see Pic. 2)
B.
Shaft holders with set screws are the “top floor”
7.
Install Bracket on the “3
rd
floor”.
8.
Using 4 #6-32 1.5”LG. screws from step 5 attach both structures to main
plate.
9.
Secure bracket axis with set screws, using 1/16” hex L-key.
10.
Install enclosed fabric sheet. Note that fabric sheet is smooth on one side and
rough on another. Rough side is conductive and should face out. Smooth
(isolated) side is facing PCBs. If you have any doubts, use conventional tester:
rough surface shows no electrical resistance.
A.
Line up upper edge of the fabric with upper edge of the bracket. Place small
bracket from 2A on the top of the fabric. Using 1/16” hex L-key install 5
screws from step 2A.
B.
Line up bottom edge of the fabric with outer edge of the bottom arc from
step 2C and using 1/16” hex L-key install 5 screws from step 2C.
C.
Install 2 screws from step 2B
11.
Cut the excess of fabric with the blade or scissors.
12.
Arecont Vision reserves the right to change products or specifications without notice ©2008 Arecont Vision
www.arecontvision.com [email protected] 818.937.0700 877.CAMERA.8
