AV818X/AV836X Tilt Adjustment Instruction A
AV8180 is supplied with 3 shaft holders stocked up on each side (further referred to as
“floors”) Camera is installed on the 2
nd
floor as a default.
If you use camera in installation such way so the center plane of the Main Bracket with 4
lenses is perpendicular to the mounting surface, you need to move camera to the 1
st
floor
to fit camera in dome. (Instruction A)
If you use camera in installation such way so the center plane of the Main Bracket with 4
lenses is parallel to the mounting surface you need to move camera to the 3
rd
floor.
(Instruction B)
PIC. 2
INSTRUCTION A:
1.
Use enclosed 1/16” hex L-key to undo set screws on the top of the “second
floor” shaft holders, while holding the bracket. Don’t completely remove set
screws from holders. Carefully place bracket on its side.
2.
Using enclosed 5/64” hex L-key remove 4 screws from shaft holders.
3.
Remove “1
st
floor” and “3
rd
floor” shaft holders from both sides. Place shaft
holders with set screws onto the main plate.
4.
Using screws from step 2 attach both holders to main plate. (see Pic. 2 for
positioning)
5.
Secure bracket axis with set screws, using 1/16” hex L-key.
6.
Cut the excess of fabric with the blade or scissors if necessary.
7. Do not discard holders as they may be used in future installation modifications.
www.arecontvision.com [email protected] 818.937.0700 877.CAMERA.8
Arecont Vision reserves the right to change products or specifications without notice ©2008 Arecont Vision
