Arec CI-T10, Руководство пользователя

Страница: 52 / 54

CI-T10 User Manual
52
Chapter 5. Camera Maintenance and
Troubleshooting
5.1 Camera Maintenance
5.2 Troubleshooting
(1) If camera is not used for long time,please turn off power adapter switch and AC plug.
(2) Use soft cloth or tissue to clean the camera cover.
(3) Use soft cloth to clean the lens; Use neuter cleanser if bad smeared. No use strong or corrosive cleanser or corrosive
cleanser avoiding scuffing.
(1) No video output
(a) Check whether the camera power supply is connected, the voltage is normal, the power indicator is lit.
(b) Whether the machine could do self-inspection after restarted.
(c) Check whether the video output cable or video display is normal
(2) No image sometimes
(a) Check whether the video output cable or video display is normal
(3) Image dithering when zoom-in or zoom-out
(a) Check whether the camera installation position is solid
(b) Whether there is shaking machine or objects around the camera
(4) Remote controller can not work
(a) Remote control address is set to 1 (if the machine is set back to the factory defaults, remote control addresses
need to be back to 1 too)
(b) Check whether the battery is installed on the remote controller or low .
(c) Check the menu whether is closed, camera control through remote controller is only available after exiting the
menu. If video output from LAN, menu will not be displayed, menu will automatically exists 30s later, then it can
be controlled by remote controller.
(5) Serial port can not work.
(a) Check whether the camera serial device protocol,baud rate, address is consistent
(b) Check whether the control cable is connected properly
(6) Web pages cannot log in
(a) Check whether the camera is showing normally.
(b) Check whether the network cable is connected properly(Ethernet port yellow light flashes to indicate normal
network cable connection)
(c) Check whether your computer is added the segment and the segment is consistent with the IP address of the
camera. For instance, if the IP address of the computer is 192.168.11.250 and the camera is 192.168.11.202, then
both are in the same network segment.
(d) Click "Start" and select "Run" and then type “cmd” in the computer;Click "OK" then turn on a DOS command
window to enter ping 192.168.11.202. Press the Enter key to appear message as follows: Description network
connection is normal