www.tekvox.com
Auto-Tracking Camera
79068-Auto10 User Manual
2.1.1 Power-On Initial Configuration
1.
Power on:
Connect the DC 12V power supply adapter to power
2.
Initial configuration:
When the camera powers on, the power indicator light turns on, the
remote control receiver light starts blinking, the camera head moves from the bottom left to
the right, and then goes to the HOME position (intermediate position of both horizontal and
vertical), while the camera module stretches. When the remote control receiver light stops
blinking, the self-check is finished.
Note
:
1.
The default address of the remote controller is #1
2.
If you set preset 0, when the Power On self-test is completed, the camera automatically moves
to the preset 0 position.
2.1.2 Video Output
Video Output from LAN
•
Network Cable Connection:
Connect the camera and your computer through network cable.
Refer to Item B in §3.1 for details on the camera’s LAN interface.
•
Webpage Login:
Open your browser and enter
the camera’s IP address
in the address bar
(factory default: 192.168.11.202). Press
“
Enter
”
to enter into the login page; click on “player is
not installed, please download and install!" and follow the installation steps for installation.
Then enter the username
“
admin
”
and password
“
admin
”
(factory default). Press Enter to enter
into the preview page; users can carry out PTZ control, video recording, playback,
configuration, and other operations. (
Note
: If you forget your username, password, or IP
address, you can manually restore the default by the remote controller key combination * # )
HDMI Video Output
•
HDMI Video Cable Connection: Refer to Item C in §3.1 for details
•
Connect the camera and the monitor via HDMI video cable; video output is available after the
camera self-test.
USB3.0 video output
•
USB3.0 video cable connection: Refer to Item D in §3.1 for details
•
Connect the camera and the monitor via USB3.0 video cable, open video display software,
select image device, and then video output will be available.
