User’s Manu
al
–
A
REBO
S Reciprocating Saw
7
3.
Assembly
•
Make sure the power supply corresponds to the voltage on the rating nameplate before
connecting it.
•
To avoid accidental start, make sure the device is switched off before to plugging in tool and
your fingers are not touching the on/off switch button.
•
Danger:
make sure that the saw cable is tightened securely before you plug in the cable. If
this is not the case, serious injuries may be caused.
•
Warning:
always hold onto the device with two hands when switching it on.
3.1 Install the Blade
(Fig. 2)
•
Do not
connect the device to the power supply when you remove or exchange a saw blade!
•
Unplug the power cord first
•
Rotate the Quick-release blade clamp (4) anticlockwise with hand
•
At the same time push blade (6) to the deepest position
and then release the quick-release blade clamp.
•
Make sure it is securely fastened.
3.2 Choosing the right blade
•
Only use saw blades, which are suitable to the material to be cut.
130 mm
e.g. for wood, plastic, aerated concrete, gypsum
plaster
80 mm
e.g.
for plastic, metal (sheet of iron, aluminium, copper,
brass, steel
3.3 Depth of adjustment
•
You can adjust the front shoe to change the depth of the cut pf your reciprocating saw. To
adjust the depth of the cut, loosen the front shoe locking nut (7) by the provided wrench. Set
your depth of cut (Note: ideal depth of cut is 1″ deeper than material to be cut) then tighten
the front shoe locking nut securely.
4.
Operation
4.1 Switch ON and OFF
(Fig. 3)
•
Connect the plug to the power supply.
•
Grasp the switch button (1) to turn switch on.
•
Press down the lock-off button (2) can locked switch in ON
position.
•
Grasp the switch button (1) again and release it to switch off
the saw.
