Ardisam Eskimo Z43, Руководство оператора

Страница: 7 / 16

Page 7
Starting and Stopping Engine
To attach auger to powerhead if not done, align hole in at
top of shaft with output shaft hole. Insert bolt and secure
bolt with provided allen wrench.
NOTE: The ends of the bolt should be flush with auger
collar. Bolt head and thread end should never go
beyond ice collar.
1. Move engine to a well ventilated area, outdoors, to
prevent carbon monoxide poisoning.
2. Move to an area away from flames or sparks, to avoid
ignition of vapors if present.
3. Remove all debris from air cleaner holes and fuel cap to
ensure proper air flow.
4. Turn switch to the ON position.
5. Priming:
•
When using the primer bulb, allow the bulb to return
completely to its original position between pushes.
•
Choke must be in the OFF position when pushing or using
the primer bulb.
First Start: Starting new engine for first time or after running
out of gas, prime 3 times.
Cold Start: Starting engine after it has been sitting or
stored briefly with fuel in the tank, prime 1 time above 55
°
Farenheit or 2 times below 55
°
Farenheit.
Warm Start: Do not use primer or full choke if engine did
not run out of gas or has not cooled completely. Flooding of
engine will occur.
6. Choke:
•
Full choke position is defined by moving the choke lever
as far to the ON position as possible. Half choke is defined
when the choke lever is between ON and OFF .
First Start & Cold Start: After priming, move choke lever to
full choke.
Warm Start: No choke or half choke is needed.
Avoid injury! If auger is mounted to engine, all safety
guards must be securely on to avoid serious injury.
CAUTION
Avoid injury! Starter rope can cause an unanticipated
jerk towards engine. Please follow instructions to avoid
injury.
CAUTION
7. Grasp starter handle and pull out slowly, until it pulls
slightly harder. Without letting it retract, pull rope with a rapid
full arm stroke. Let it return to its original position very
slowly. Repeat this step everytime the starter rope is pulled.
8. Pull recoil until engine fires or runs.
NOTE: If engine fails to start after 5-6 pulls, push primer
1 time and pull starter rope again.
9. After engine starts running, move choke lever to HALF
CHOKE .
10. Run engine for 30 to 45 seconds at half choke position
until engine warms up.
11. Move choke lever to OFF position and move throttle to
desired speed.
12. To stop, flip switch to OFF position.
DO NOT attempt to start engine in the following ways:
·
DO NOT use starting fluid.
·
DO NOT spray flammable liquids or vapors into air
cleaner, carburetor or spark plug chamber.
·
DO NOT remove spark plug and pull on starter rope.
Flammable fuel can spray out & ignite from a spark
from spark plug.
Avoid injury! If engine fails to start after the above
operations, please contact Ardisam, Inc. at 1-800-345-
6007.
CAUTION
Avoid injury! Never leave engine running while
unattended. Turn off after every use.
CAUTION
Avoid injury! Never carry powerhead and auger between
holes while engine is running.
CAUTION
OPERATION