ARDESTO RVC-S1200B, Инструкция по эксплуатации, Страница: 64 / 80

EN
64
Function Description
Spot Cleaning Sweep the small area where the machine is located back and forth once
Along the wall 1. Press this key and the vacuum cleaner will enter the along-wall cleaning
mode.
2. It will enter the recharge mode automatically after sweep in along-wall
mode is finished.
Small room 1. Press this key and the vacuum cleaner will enter the small room sweep
mode.
2. The vacuum cleaner will sweep your room automatically for 30 minutes
in this mode.
3. After sweep is completed, it will automatically enter the recharge mode.
Time settings 1. Press this key with the machine ON, and on
88
the display screen will
flash. Now press the up/down key to adjust the hour.
2. Press the left pivoting key or right pivoting key to switch to for
minute adjustment.
3. When settings are completed, press the Start/Stop key or the Time
Settings key to save them.
Appointment
1. Press this key with the machine ON, and and
88
on the display screen
will flash. Now press the up/down key to adjust the hour.
2. Press the left pivoting key or right pivoting key to switch to for
minute adjustment.
3. When settings are completed, press
or to save them. Upon receipt
of the instruction sent by the remote control, the vacuum cleaner will
respond with a beep.
4. Press and hold "
" to cancel appointment settings.
Recharge
1. Press this key and the vacuum cleaner will enter the recharge mode.
Suction regulation:
Key combination
and Switching among levels (1st - 3rd):
1. The buzzer beeps once: Suction Level 1
2. The buzzer beeps twice: Suction Level 2
3. The buzzer beeps three times: Suction Level 3
Note:
If the vacuum cleaner does not respond to commands from the remote control,
check if the battery is dead. If the vacuum cleaner cannot be operated with a sufficient
charge level, please re-match the frequency of the remote control.
To re-match the frequency of remote control:
(First confirm that the vacuum cleaner and the remote control have sufficient power,
and then proceed as follows).
1. Turn off the power switch
2. Press and hold the direction center key
on the remote control, wait until the clock symbol
flashes and then turn on the machine power switch. Frequency matching is successful when the
buzzer beeps three times.
Note:
If you hear no beep, it means that frequency matching has failed. Please repeat the above
process.