EN
13
TIPS:
1. Rotate the knob to the middle position after coffee brewing, will help to remove the
porta-filter easily.
2. Max brewing time is 45S, and machine automatically stop brew coffee.
Milk Frothing
The unit will dispense a few amount of water to the drip tray, when the machine is in
standby mode or preheating for steam function and the knob is rotated to middle
position. This is normal.
1.Pour desired amount of milk into the milk jug.
IMPORTANT:
The milk must be at refrigerator temperature(not hot!)
2.Place the milk jug under the frothing wand. Dip the frother into the milk jug. Rotate the
knob to steam function.
3.Press down the start button. The button starts to flash. The unit will start making steam
out of the steam wand. 3.Rotate the milk jug with slow movements from the bottom
upwards. Until your desired foaming is reached, rotate the knob back to middle position
and your milk froth is ready.
4.After finishing, the machine will return to standby state.
5.Remove the milk jug away. Use a damp cloth to remove the milk residue on the steam
wand.
ALWAYS CLEAN THE STEAM WAND AFTER EACH USE TO REMOVE THE MILK RESIDUE.
THE STEAM WAND CAN BE HOT. TAKE IT WITH CARE WHEN REMOVE AND CLEAN.
Cleaning and Care
NOTES
• Before commencing the cleaning, note the safety instructions in the “Safety Instructions”
chapter!
• Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean
the device. These can damage the surface.
1. the filter after every use with mild detergent and warm water .
2. If necessary, clean the water tank (11) and the drip tray (7) and the cover (6) with mild
detergent and warm water.
3. Regularly run the cleaning (see “Self-Cleaning”) to the coffee outlet on the porta-filter .
4. Wipe down the housing with a damp cloth. If necessary, use a little mild detergent to
remove more intense soiling.
5. Thoroughly dry the device and all accessories before assembling it again.
6. Check the mains cable regularly for any damage.
