ARDESTO CHH-2000MBR, Руководство пользователя

Страница: 10 / 24

EN
10
SAFETY REQUIREMENTS
Before connecting the convector to the power supply, be
sure to visually check the power cord and the convector
for mechanical damage. If there are damages, contact an
authorized service center for repair. Before repairing damage, it
is not allowed to connect the convector to the power supply.
Disconnect the convector from the power supply during its
maintenance, wet cleaning of the room near the convector
installed on the floor.
Disconnect the electric convector from the power supply by
holding the plug of the power cord.
Do not use this heater near bathtubs, showers or
swimming pools.
Do not use the device in rooms with high humidity.
Place the device at a distance of not less than 1.5 meters from
open flame.
Provide that no water gets on the device body.
If any water gets on the device body, unplug the device before
touching it and only then wipe water drops.
Always use the supporting legs when placing the device and
place the device on a flat steady surface. Before using the
device make sure that the legs are installed properly.
Do not use the device in the rooms where inflammable
substances are kept or used.
Do not use the device, if the room temperature is over +30°C.
Do not leave the switched on device when sleepingand do not
place it near a sleeping person.
Do not allow paper or foreign objects inside the convector.
Do not use the convector for other purposes (the convector is
not intended for outdoor use).
Do not operate the convector with damaged power cord.
Make sure that the power cord does not not touch sharp
corners and heated surfaces of the convector.