arcus-eds
I
KNX
SYS
IP
KNX System Devices
Application Description
Gateway KNX-GW-IP-2TE
Arcus-EDS GmbH
Rigaer Str. 88 , 10247 Berlin
Tel.: +49 / (0)30 / 2593 3914
Fax.: +49 / (0)30 / 2593 3915
e2
Subject to change
Page 9
8 KNX Group Monitor
Using the KNX-group monitor allows for the monitoring and transfer of telegrams via the KNX-bus in real time. The site of the
KNX-group monitor is subdivided into a configuration and a telegram section.
Within the configuration can a 2- or 3- stage adressing be selected and communication of the physical adresses be hidden.
For the display, automatic scrolling can be either enabled or disabled and an address filter can be set for monitoring specific
addresses. In this way, a filter can be applied to a singular address, whole main- and sub groups, or address ranges.
Filtering example:
Within the group monitor itself, several lines
( max 100 lines )
can be displayed for one specific group adress.
Each line allows for one value to be written or read in the individual group address. The current value is then displayed at the end
of the line with a time stamp. In addition to one-time sending, periodical sending is also possible. In the case of recurring tasks,
the configuration can be saved
( locally on your PC )
then restored for future use.
The table below the lines shows all telegrams which fit the set parameters. The approximate bus utilization and the amount of
repetitions is displayed below the table every second.
[ blank ]
All telegrams are displayed.
1/1/0
Only telegrams of the group address 1/1/0 are displayed.
1/1/0 1/5/0
All telegrams of the group adresses 1/1/0 und 1/5/0 are displayed.
1/1/*
All telegrams of the subgroup 1/1/ are displayed.
1/1,3,22/*
All telegrams of the subgroups 1/1/ , 1/3/ and 1/22/ displayed.
1/1-6/4,5,30
All telegrams of the group adresses
1/1/4 , 1/1/5 , 1/1/30 , 1/2/4 , 1/2/5 , 1/2/30 , 1/3/4 , 1/3/5 , 1/3/30
1/4/4 , 1/4/5 , 1/4/30 , 1/5/4 , 1/5/5 , 1/5/30 , 1/6/4 , 1/6/5 , 1/6/30 are displayed.
Seite 9
