arcus-eds
I
KNX
SYS
IP
KNX System Devices
Product Page
Gateway KNX-GW-IP-2TE
Arcus-EDS GmbH
Rigaer Str. 88 , 10247 Berlin
Tel.: +49 / (0)30 / 2593 3914
Fax.: +49 / (0)30 / 2593 3915
e2
Subject to change
Page 15
12 Product Page
The
KNX-GW-IP-2TE
is used for coupling the ETS ( PC software tool )
via Ethernet to the KNX bus for addressing and programming
KNX components.
Using the KNX-group monitor allows for the monitoring and transfer of
telegrams via the KNX-bus in real time. The site of the KNX-group monitor is
subdivided into a configuration and a telegram section.
The KNX-IP-gateway is able to save telegrams. The KNX-telegram logger lists
the saved telegrams. It is possible to set a timeframe as well as a group
address filter.
To visualize the data, up to three different group addresses can be displayed in
one graph.
The gateway can link html-sites with KNX-files and visualize them in every
browser, provided that websockets are supported.
All selected functions are switched off by actuating of the safety
switch.
13 Technical Data
General information
To use groupmonitoring and telegramlogging your browser must support websockets. If this is not the case, a notification will be
displayed on the respective pages.
In certain instances, such as the device being shut down right after a change in configuration, a loss of configuration files may
occur. In that case the red RESET-LED will blink periodically during rebooting. To reset the device hold down the RST-key during
booting until the RESET-LED turns off and then back on again. Please note that it is recommended to wait 10 seconds after a
change in configuration before shutting the device down. Save your configurations to restore them loss-free.
To mount a µSD-card insert the card with the mount-switch turned off. Then switch it on. If a µSD-card fails to mount, turn the
switch to ´unmount´ again, remove the card, and repeat the steps.
Technical Data - KNX-GW-IP-2TE
Operating voltage
9 .. 30VDC max. 1,5W
2-pin terminal with screws
Terminal bus voltage
KNX 2-pin terminal ( red / black )
Power consumption (KNX)
approx. 120mW (at 24V DC)
Ambient temperature
storage -25 .. +85°C
operation -25 .. +55°C
Ethernet
10/100 Mbit/s RJ45
USB
in preparation
Protection
IP20
Mounting
DIN rail mounting
Housing
plastics housing DIN rail / 2 Units ( 35 mm )
Article number
40400002
Article No. 40400002
KNX-GW-IP-2TE
Seite 15
