OWNER’S MANUAL: EDGE
-SERIES
–
SWING GATE WALL MOUNT CABINETS
9
© 2018 ArcTiv Technologies, LLC
ATSGWM-MANUAL-01
Vertical Lacing Bar Installation
The vertical lacing bars provide strain relief for large cable bundles
routed between the front and rear Revi-
Ring™ Vertical Cable
Managers and also a 0U mounting option for small, IT devices. The
brackets connect to the horizontal rails with (4) screws and cage
nuts (included).
Rear Equipment Mounting
The back gate includes 2 welded 2U mounting rails for vertically
installing small devices such as PDU and patch panels. The
mounting rails include square holes for use with cage nuts and
screws. It is recommended to allow enough cable slack to allow full
swing gate operation
The 4-post mounting rails also allows for rear equipment mounting
of small devices. Make sure to appropriately configure the rear
mounting rails to provide adequate space for these devices in order
to shut the back gate without obstruction.
Fan Kit Installation
Each cabinet includes mounting provisions for low-noise or
standard fan kits on both the top and bottom panels. Each fan
installs with 4 mounting screws and is powered with local plug
options.
The power cables can be routed via the Vertical Lacing Brackets and
Revi-
Ring™ Vertical D
-Ring Managers.
EIA Equipment Installation
EIA equipment and accessories can be installed on both the front
and back rails via cage nuts and M6 screws (included). Standard
Edge-Series accessories include:
•
Blanking Panels
•
Horizontal D-Ring Managers
•
Horizontal Cable Managers
•
Horizontal Lacing Bars
•
Fixed and Sliding Shelving
Cable Entry Brush and Grommet
The cable entry brush and grommet are included with the standard
models on the back side of both the top and bottom panels. To
open the grommet hole, use a screw driver to open the seal and
route the power or network cables. The brush strip can provide a
sealed option to maintain organization and isolation.
Mounting Feet Installation
Each cabinet can support a pack of 4 mounting feet (not included)
which can be used for floor or desktop mounting. Each kit can be
installed with a Philips screwdriver.
