Arctic AG10E, Руководство пользователя

Страница: 11 / 31

AG6E/AG8E/AG10E
Page 11 www.arcticsnowplows.com
Troubleshooting of the Wireless Controller
It is important to know that the in-cab remote control and the controller on the spreader
communicate with RF signals. Therefore, they are in constant communication with one another.
This type of communication allows you to get instant info on your setting and it will also inform
you on any problems that could happen during the use of your spreader.
Never hook booster cables directly to the motor; this would void your warranty.
Unplug sander battery cables before boosting your truck.
Problems:
-
When the screen on the remote shows ‘’O’’ it means that the system is in OVERLOAD
An overload of the system can caused by:
•Frozen material inside the hopper.
•Accumulation of material in front and under the spreader
•Bearing starting to seize
•Worn-out conveyor chain
•Accumulation of material between the floor of the spreader and the drive sprockets.
•Battery in bad condition
•Controller poorly installed
-
When the ‘’O’’ is constantly rotating, this means, there is no communication (loss of
signal) between the remote control and the control box. The spreader will automatically
shut off.
By turning the main switch off and then turning it back on, the signal should come back.
If the signal doesn’t come back you can connect the remote directly to the black box by
using the appropriate connectors on the controller. This operation will reset the system.
If the problem persists here are some possibilities:
•Power is not going to the controller (black box)
•Check fuses ( 5 amp and 80 amp)/ Breaker engaged (if applicable)
•Bad connections
•Electrical noises or interferences
•Poorly installed controller
Programing:
If you install new controller or if there is the ‘’O’’ is constantly rotating, program the controller
following this instruction. On/Off switch must be in ON position. Hold AUX or SYNC button on
the controller before plugging in. Plug the controller in, “O” should stay on (that means the
controller is programed).