Arctic King 15625013, Руководство оператора

Страница: 7 / 25

INSTALLATION INSTRUCTIONS
7
NOTE: The top rail hardware and the Fig. A,
Fig. B and Fig. C are not applicable to the units
more than 10000 BTU/hr.Before installing unit,
the top rail must be assembled on the unit (for
<10000 BTU/hr models only).
Lower sash must open sufficiently to allow a clear
vertical opening (H). See Table 1 for correct size.
Side louvers and the rear of the AC must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit must
be outdoors not inside a building or garage.
PREPARE THE WINDOW
1
Mounting Hardware
PREPARE AIR CONDITIONER
2
A: Remove the air conditioner from the carton and
place on a flat surface.
B: Remove top rail and
ENERGY STAR models) from the packaging
material as shown in Fig. A.
R1 panel (R1 panel only for
Top Rail Hardware
3/8 (10mm) screws
(4)
Top rail
(1)
Packaging
Fig. A
Top rail
C: Align the hole in the top rail with those in the top
of the unit as shown in Fig. B
D: Secure the top rail to the unit with the 3/8 (10mm)
screws as shown in Fig. C.
NOTE: For safety reasons, all four (4) screws MUST
be securely fastened.
INSTALL THE ACCORDION PANELS 3
NOTE: Top rail and sliding panels at each side are
offset to provide the proper pitch to the rear of 5/16
(8mm). This is necessary for proper condensed water
utilization and drainage. If you are not using the side
panels for any reason, this pitch to the rear must be
maintained.
A. Place unit on floor, a bench or
a table. Hold the accordion
panel in one hand and gently
pull back the centre to free the
open end. See Fig. 1.
Fig. 1
R1 panel
(1)
R1 hardware (for
)
<10000 BTU/hr models
only
R1 hardware
(for >
)
10000
BTU/hr models
only
3/4" (19 mm)
or 1/2" (12.7 mm)
screws
(7)
Lock
frame
(2)
Sash
lock
(1)
Window sash
seal foam
(1)
Weather
stripping
(5)
(10 *3/4 *1/12 )
Fig. C
Fig. B