100
CC893
6. Place the input shaft housing assembly onto the gear
case housing; then secure with the existing cap
screws. Tighten to 18 ft-lb.
CD103
CD110
Removing Needle Bearing
NOTE: Removing the needle bearing is rarely nec-
essary. Avoid removing the needle bearing unless the
bearing is clearly damaged.
NOTE: This procedure can be performed on a rear
gear case.
1. Place a 1/4 in. drill bit on the inside surface of the
needle bearing (against the bottom side); then drill
through the pinion shaft needle bearing housing.
CC885
2. Using a propane torch, heat the area surrounding the
needle bearing to soften the Loctite.
CC886
3. Using a flat-nosed punch, drive the bearing out of the
housing.
CC887
Installing Needle Bearing
1. Apply green Loctite #609 to the outside of a new
bearing; then place the new bearing into the housing.
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com