Arctic Cat Jaguar Z1, Руководство оператора

Страница: 31 / 56

MAINTENANCE 27
3. Look through the clear side of
the fuse to see if the metal wire
inside is separated. If it is, the
fuse is blown and should be
replaced with a fuse of the cor-
rect amperage rating.
4. Install the fuse panel cover.
Even after replacing a fuse, it may
continue to blow if the cause of the
overload is not determined. If the
fuse continues to blow, take the
snowmobile to an authorized Arctic
Cat Snowmobile dealer for service.
If not under warranty, this service is
at the discretion and expense of the
snowmobile owner.
HYDRAULIC BRAKE SYSTEM
Arctic Cat recommends that the
brake system (brake lever, fluid res-
ervoir, hose, caliper, pads, and brake
disc) be checked daily for fluid leak-
age, wear, or damage and for proper
operation. Also, the brake fluid level
must be checked every time before
starting the engine. The brake fluid
must be maintained at a level in
which the sight glass appears dark.
Checking/Adding Brake Fluid
1. With the fluid sight glass reser-
voir in a level position, check
the fluid level. The brake fluid
level must be visible in the sight
glass.
„
NOTE: If the sight glass appears
dark, there is a sufficient amount
of fluid in the reservoir.
741-328A
2. If the brake fluid level is not
visible in the sight glass,
remove the reservoir cover and
add Arctic Cat approved brake
fluid until the fluid is at the rec-
ommended level. Install and
secure the reservoir cover. Do
not allow moisture to contami-
nate the brake system.
! WARNING
Always replace a fuse with one
h a v i n g t h e s a m e s p e c i f i e d
amperage rating. Using a fuse
with a higher rating can cause
severe wire damage and could
start a fire.
! WARNING
DO NOT operate the snowmo-
bile when the brake lever lock is
engaged or when any compo-
nent in the brake system is dam-
a g e d , w o r n , o r a d j u s t e d
improperly. If the snowmobile is
operated and the brake system
is not functioning properly,
severe personal injury could
result.
! CAUTION
Brake fluid is highly corrosive.
Do not spill brake fluid on any
surface of the snowmobile.