58
5. Pour 150 ml (5 fl oz) of recom-
mended lubricant into the fill plug
hole; then install the fill plug and
tighten securely.
6. Start the engine and drive the ATV
to warm up the rear drive; then
check for any leaks around the drain
and fill plugs.
Hydraulic Brakes
Brake Fluid
Check the brake fluid level in the hand
brake fluid reservoir. If the level in the
reservoir is below the lower mark in the
sight glass, add DOT 4 brake fluid.
KM161D
Check the brake fluid level in the auxil-
iary brake fluid reservoir.
If the level in the reservoir is below the
LOWER mark, add DOT 4 brake fluid.
KM137
Brake Hoses
Carefully inspect the hydraulic brake
hoses for cracks or other damage. If
found, take the ATV to an authorized
Arctic Cat ATV dealer to have the brake
hoses replaced.
Brake Pads
The clearance between the brake pads
and brake discs is adjusted automatically
as the brake pads wear. The only mainte-
nance that is required is replacement of
the brake pads when they show excessive
wear. Check the condition of each of the
brake pads as follows:
1. Remove a front wheel.
2. Measure the thickness of each brake
pad.
3. If thickness of either brake pad is
less than 1.0 mm (0.039 in.), take the
ATV to an authorized Arctic Cat
ATV dealer to have brake pads
replaced.
PR376B
4. Install the wheel and tighten using a
crisscross pattern to 40 ft-lb.
Brake Lever Lock
Check to make sure the brake lever lock
engages properly and that the brake
(when engaged) locks the wheels.
1. Pump the brake lever 2 or 3 times.
2. Engage the brake lever lock.
! WARNING
Be sure to inspect the hydraulic
brake system before each use.
Always maintain brakes according
to the Maintenance Schedule.
CAUTION
Be careful not to spill any fluid when
filling the brake fluid reservoir. Wipe
away spilled fluid immediately.