
52
2. Release the two ends of the
springclip from the headlight
housing taking care not to bend
or deform the clip; then remove
the bulb from the housing.
3. Install the new bulb into the
housing; then secure with the
spring clip.
4. Connect the three-wire connector
to the bulb; then install the rub-
ber boot.
5. Install the wiring harness con-
nector.
Brakelight
To replace the brakelight bulb, use the following procedure.
1. Remove the two screws and remove the lens cover.
2. Push the bulb in and turn it counterclockwise.
3. Install the new bulb by turning it clockwise while pushing in.
4. Install the lens cover.
Fuse
The main (7 amp) fuse is located in a
fuse holder near the battery under the
seat.
NOTE: To replace the fuse, open
the holder and remove the fuse;
then install the new fuse. A spare
fuse is located within the holder.
If there is any type of electrical system failure, always check the fuse
first.
Storage Compartment/Tools
A basic tool kit is provided with the
ATV. It is located under the seat.
Maintain the tool kit with the ATV
at all times.
CAUTION
When replacing the headlight bulb, be careful not to touch the
glass portion of the bulb. Grasp the new bulb with a clean cloth.
CAUTION
Tighten the lens cover screws only until they are snug.
KM192A
KM195
CAUTION
Always replace a blown fuse with a fuse of the same type and
rating. If the new fuse blows after a short period of use, consult
an authorized Arctic Cat ATV dealer immediately.
KM031A
KM029
Содержание 2011 ATV 90
Страница 61: ...59 NOTES ...
Страница 62: ...60 Maintenance Record DATE SERVICE PERFORMED NOTES ...