Archtek telecom 5634BIF, Руководство пользователя

Страница: 31 / 49

5634BIF User’s Manual
31
S-Register Range Default Description
S6 4-255
seconds
4 Dial tone wait time
Register S6 determines how long the modem
waits before dialing the first digit in Dial
command line. This feature is convenient when
it takes longer than two seconds to obtain a dial
tone.
S7 1-255
seconds
50 Carrier wait time
Register S7 tells the modem how many seconds
to wait for a remote modem's carrier signal
before hanging up. The S7 value can be
increased if the modem does not detect a
carrier within the specified time. If the modem
detects a remote carrier signal within the
specified time, it sends a
CONNECT response
and enter data mode. If it does not detect a
remote carrier within the specified time, it sends
NO CARRIER , hangs up, and remains in
command mode.
S8
0-255
seconds
2
Comma pause time for dial delay
Register S9 tells the modem how many seconds
to pause for each comma (,) in a Dial command
line. The comma is used when dialing through a
PBX or other special telephone service to wait
for an outside telephone line.
S9 1-255
tenths
of a
second
6 Carrier detect response time
Register S9 tells the modem how long the
remote modem's carrier signal must be present
so the modem does not mistake the signal for a
busy signal, ring, or voice. The default setting
requires the modem to the carrier signal for at
least 0.6 seconds before recognizing it.
Increasing the time in this S-Register reduces
the chances that the modem will mistake noise
such as a busy signal or voice foe carrier signal.
S10
1-255
tenths
of a
second
14
Carrier loss time
Register S10 sets the time between the loss of
a remote modem's carrier signal and when the
modem disconnects. This allows the remote
modem's carrier signal to momentarily
disappear from the telephone line without the
modem disconnecting.
S11 50-255
ms
95 Touch-Tone speed
Register S11 controls the speed of the Touch-
Tone (DTMF) dialing. Increasing this value to
255 slows the dialing rate to 1.9 digits per
second. Do not select a value less than 50
milliseconds. (Register S11 does not effect
pulse dialing, which is fixed at 10 pulses per
second.)