7
IMPORTANT PRECAUTIONS
This symbol is used to alert the user to the
presence of important operating and maintenance
(servicing) instructions in the literature
accompanying the product.
This symbol is used to alert the user to the
presence of “dangerous voltage” within the
product enclosure that be of sufficient magnitude
to constitute a risk of electric shock to persons.
CAUTION:
Risk of electrical shock - DO NOT OPEN!
CAUTION:
To reduce the risk of electric shock, do not remove
cover. There are no user serviceable parts inside. Refer
servicing to qualified service personnel.
WARNING:
To prevent electrical shock or fire hazard, do not
expose this appliance to rain or moisture. Before using this
appliance, read the operating guide for further warnings.
1.
Save the carton and packing material even if the
equipment has arrived in good condition.
Should
you ever need to ship the unit, use only the original
factory packing.
2.
Read all operating instructions in this manual and
on the back of the unit.
Retain all instructions for
future reference.
3.
Follow all instructions printed on unit chassis for
proper operation.
4.
Do not spill water or other liquids into or on the unit
,
or operate the unit near water, i.e., a bathtub, sink,
swimming pool, wet basement, etc.
5.
Connect only to a power supply of the type marked
on the unit adjacent to the power supply cord
connector.
Damage caused by connection to
improper AC voltage is not covered by any
warranty.
6.
Power supply cords should be handled carefully.
Never walk or place equipment on power supply
cords.
Periodically check cords for cuts or signs of
stress, especially at the plug and the point where
the cord exits the unit.
7.
Always operate the unit with the AC ground wire
connected to the electrical system ground. Never
break off the ground pin on the power supply cord.
For more information on grounding, write for our
free booklet Shock Hazard and Grounding.
8.
Have gain controls on amplifiers turned down during
power-up to prevent speaker damage if there are
high signal levels at the inputs.
9.
Power down and disconnect units from mains
voltage before making connections.
10.
Disconnect unit from power supply before cleaning.
Metal parts can be cleaned with a damp rag.
11.
This product should not be used near stoves, heat
registers, radiators, or other heat producing
devices
.
12.
Do not block the fan intake.
This product should be
located so that its position does not interfere with
its proper ventilation. It should not be placed flat
against a wall or placed in a built-in enclosure or
rack that will impede the flow of cooling air.
13.
The user should not attempt to service this
equipment. Do not remove the cover.
All service
work should be performed by a qualified service
technician.
14.
Do not drive the inputs with a signal level greater
than that required to drive equipment to full
output.
Peavey Electronics is not responsible for
damage to loudspeakers for any reason.
15.
Do not ground any + (“hot”) terminal. Never connect
a + (“hot”) output to ground or to a (“hot”)
output
!
16.
The user should not attempt to service this
equipment.
Equipment should be serviced by
qualified service personnel when:
A.
The power supply cord or the plug has been
damaged;
B.
Anything has fallen, or been spilled into the
equipment;
C.
The equipment has been exposed to rain;
D.
The equipment does not appear to operate normally,
or exhibits a marked change in performance;
E.
The equipment has been dropped, or the enclosure
damaged.
17.
If you need set-up or operation assistance for
this product, please call Architectural Acoustics
Customer Service, Tech Service or your local
authorized dealer.