Archgard 31-DVIE33C, Руководство пользователя по установке, эксплуатации и техническому обслуживанию

Страница: 37 / 44

31-DVIE33C
37
REPLACING COMFORT BLOWER
1. Remove the glass door. Follow GLASS DOOR REMOVAL instructions within this manual.
2. Remove the BURNER MEDIA.
3. Remove the pan burner. Follow instructions for CHANGING MAIN BURNER ORIFICE within
the conversion section of this manual.
4. Remove the access cover (section set at 45 degree angle) of the firebox by removing the 1/4 “
hex head screws.
5. Remove the four nuts holding the fan in place.
6. Disconnect the wires.
7. Mark all wires to be removed for proper reassembly.
8. Install new fan in reverse order.
9. Reverse these steps after new fan is installed & tested.
C A U T I O N
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing
.
This appliance, when installed, must be electrically grounded in accordance with local codes or, in
the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70 , or the Canadian
Electrical code, CSA C22.1.
N O T E
 Make sure the gas to the appliance has been shut off.
 Ensure that the main power and breaker system is turned off before removing the fan.
 Make sure the fireplace has been turned off and is cool to the touch.

Mark all wires to be removed for proper reassembly.
I M P O R T A N T
Wiring errors cause improper and dangerous operation.
TO ACCESS FROM THE BACK
1. Remove the surround by lifting up and forward.
2. Disconnect the gas line.
3. Disconnect the intake and exhaust liners
4. Remove the insert from the fireplace.
5. Remove 1/4” hex head screws and the cover plate at the back of the insert
6. Remove the 1/4” hex head screws holding the fan bracket.
7. Disconnect the wires.
8. Remove the 4 nuts holding the fan to the bracket.
9. Replace the fan with the new fan.
10. Reassemble in the reverse order. Making sure to re-seal the venting.
TO ACCESS FROM THE FRONT
The convection fan can be accessed either through the front or through the back of the insert.