Do not install or store the appliance where it will be exposed to the weather
or temperatures below freezing.
Make sure the luminaire is mounted securely on the tank before operating it.
Read and observe all the important notices on the appliance.
DO NOT SUBMERGE ANY PART OF THIS LUMINAIRE!
SAVE THESE INSTRUCTIONS
Lamp Installation
Your luminaire is not supplied with a lamp. We recommend that the relevant
wattage and colour Arcadia lamp is used. Please ensure that the correct
wattage lamp is used.
Unplug the luminaire before installing the lamp.
To install a lamp:
- unscrew the ring from each Ultra Seal® lampholder
- fit the rings onto either end of the lamp as shown in
illustration 2
- align pins on lamp to the lampholder holes and insert the lamp by pushing
the lamp directly into the lampholder
(see illustration 2)
.
- screw the rings tightly onto the lampholder body. Do not twist the lamp
within the lampholder
(see illustration 3)
.
The ring is fully tightened when there is no gap between the ring and the
body
(see illustration 4 & 5)
.
Ensure that the ring is not cross-threaded
(see illustration 6)
.
To remove the lamp, switch off and unplug the supply, undo the ring from
the lampholder body and pull the lamp directly out from the lampholder. Do
not twist the lamp in any way
(see illustration 7)
.
Never use this Ultra Seal® controller without lamps in place.
NOT SUITABLE FOR USE WITH UVC LAMPS.
Physical Installation
Select a suitable site close to your electricity supply. Always place the
controller on it’s base in an upright position
(see illustration 8)
.
Place the controller on a firm surface and NOT on carpets or similar fabric
surfaces.
Fitting the mounting brackets:
Use suitable fixings for the mounting surface. For mounting dimensions,
refer to
illustration 9
.
The mounting bracket is suitable for a vertical or horizontal mounting
surface - please ensure that the lampholder cable and insulation remain
unstressed,
(see illustration 10, 11 & 12)
.
Do not mount directly to the aquarium glass.
4
