ARC Flex Mini, Инструкция по эксплуатации

Страница: 15 / 18

Flex Mini Instruction Manual
November 2015
Page 14 of 17
PB3 PB4
PB5 P B6
P B8 PB7
START
Type 3
STOP
PB3 PB4
PB5 P B6
P B8 PB7
P B2
ON
OF F
Type 2
PB3 PB4
PB5 P B6
P B8 PB7
P B2
Type 1
PB1
4. OPERATING PROCEDURE
General Operating Procedure
Keypad Type 1:
The transmitter is powered on and operated by pressing any button on the
keypad (green blinks on Status LED). The transmitter goes into sleep mode
after 5 minutes of inactivity (buttons not pressed). Press any button to wake
up the transmitter and continue operation.
Keypad Type 2:
The transmitter is powered on by pressing the On/Off button one time for up
to 2 seconds (green on Status LED); the receiver main is also activated at
the same time. The Status LED will blink green every 4 seconds thereafter
for up to 5 minutes when no buttons are pressed (transmitter standby). After
5 minutes the transmitter will go into sleep mode. Press the On/Off button for
up to 1 second to wake up the transmitter and continue operation. Shut off
the transmitter power by pressing the On/Off button for up to 2 seconds (red
on Status LED and then off); the receiver main is also deactivated at the
same time. The system will not work when pressing any buttons prior to
initiating the On/Off command (Status LED blinks 2 red).
Keypad Type 3:
The transmitter is powered on by pressing the Start button one time for up to
2 seconds (green on Status LED); the receiver main is also activated at the
same time. The same Start button becomes an auxiliary function thereafter.
The Status LED will blink green every 4 seconds thereafter for up to 5
minutes when no buttons are pressed (transmitter standby). After 5 minutes
the transmitter will go into sleep mode. Press the Start button again for up to
1 second to wake up the transmitter and continue operation. Shut off the
transmitter power by pressing the Stop button for up to 2 seconds (red on
Status LED and then off); the receiver main is also deactivated at the same
time. The system will not work when pressing any buttons prior to initiating
the Start command (Status LED blinks 2 red).
Changing Transmitter Batteries
Changing transmitter batteries (“AA” alkaline battery x 2) by unscrewing the battery cover
located on the backside of the transmitter counterclockwise. During battery installation
make sure the batteries are installed correctly, “+” to “+” charge and “–” to “–” charge. Also
make sure the screw is tightened after battery installation to avoid water, moisture, dirt,
grease, or other liquid penetration.