ARC Audio XDi 850.5 страница 3 Скачать руководство пользователя

Страница: 3 / 9

DIAGNOSTIC FAULT CODES

Thermal (Heatsink)

The Amplifier has Over Heated. Turn the volume down and let it cool off

Thermal (Transformer)

The Power Supply Transformer has Over Heated. Turn the volume down and let it cool off.

Code 11

Under Voltage

The Battery Voltage it too low. I bet your car won’t start. If it does, you have a bad connection.

Code 12

Short (Low Power Channel)

Shorted speaker or wire on Channels 1-4. Turn the system off unill you can get this fault corrected. Also includes internal shorts.

Code 13

Repeated Shorts

You didn’t turn the system off, did you?

Code 14

Over Voltage

Your Alternator is Over-Charging. Have your vehicle’s electrical system tested right away.

Code 15

DC Output Protection

DC Current was detected on the speaker line and to avoid damaging the speakers, this amplifier has shut down. This will probably require factory service.

Code 16

Short (High Power Channel)

Shorted speaker or wire on subwoofer channels (5 or 5-6) also includes internal shorts.

Normal Turn on

Blue is good. This is normal self test and turn on delay.

Power/Processor Reset

You will see this the first time the amplifier is powered up or the microprocessor resets. This code will vary from model to model.

Long

Short

Long

Short

Flash

Short

Warning
Take extra care when using CCA (Copper Clad Aluminum) or pure aluminum wire to insure the connections as clean
and tight. Do to aluminums highly reactive nature these connections can fail without the typical "Green" or tarnished
look you would expect with copper. Aluminum also has a greater rate of expansion do to heat and care must be taken
to insure that the connection is not over tightened. This can result in the failure of the power or ground connector and
possibly the circuit board.

Recommendations for all Class D amplifiers

Class D amplifiers by the nature of there design emit a certain amount of RF (Radio Frequency) radiation. While we have
optimized the design to reduce this to a minimum level there are still steps you can take to eliminate any unwanted FM
radio interference. The tips below apply to any class D amplifier.

Always mount the amplifier as far from the antenna as the installation will allow. At the same time you will want to keep it
away from the radio or any other electronics that may prove to be sensitive to FR radiation.

Make the ground wire as short as possible. Think of the ground like it is an antenna. Short antennas do not work as well.

Use twisted pair wires as much as possible. If you can manage it all the speaker wire and input cable weather by RCA or
speaker level should be twisted. If you do not have twisted pair wire you may be able to twist it yourself.

If you encounter a problem with FM interference you can try turning the amplifier 90 degrees or changing its location
completely. RF radiation can be very directional.

Running the Cables

Carefully run the power and signal cables through the passenger compartment of the vehicle. Running power down one
side and signal down the other is the preferred method. If this isn’t possible, keep them separated as much as possible.
When running through any metal, always use a rubber grommet to prevent the power wire from shorting and to reduce
the risk of fire. A 4 gauge or larger wire should be used for power and ground connections. ALWAYS install a fuse on the
power wire within 18 inches of the battery for safety.

Top