©2016 Arbor ScIentIfIc. All rIghtS reServed.
Po box 2750, Ann Arbor, MI 48106-2750
t
800 367-6695 www.ArborScI.coM
Wall mount power supply:
Input: 120VAC/60Hz 0.2A;
Output: 15VDC, 1A, UL listed
Dimensions: 7 x 4.5 x 4 cm + contact blades,
1.9 m cord length
Weight: 100 g
Tube energizing supply:
1.8kV AC (internal)
Power Supply & Carousel:
Dimensions: 23 cm diameter x 23 cm high
Weight: 1.55 kg
Fuse:
T1AL 250V, 5 x 20 mm miniature
Height of center of light-emitting region
above bench:
13.3 cm
Length of light-emitting region:
4.75 cm
Tube:
Dimensions (in shell): 15.5 x 4.0 x 3.0 cm
Weight: 88 g.
operation
CAUTION! THIS UNIT IS SUITABLE FOR OPERATION IN
DRY LOCATIONS ONLY! THE TUBE BECOMES HOT IN
OPERATION! DO NOT TOUCH THE HOT TUBE!
Inserting a tube
Tubes can only be inserted into the carousel at one
location. To ensure correct orientation of the tube in the
tube well, the tube shell has a ridge along the front right
side.
Rotate the carousel unit an empty location aligns with
the tube insertion aperture.
Inserting a tube
Match the ridge on the tube shell to the insertion
aperture on the top of the power supply. The round
magnet cover on the rear of the shell should be facing
down.
End of tube - back view
Insert the lower end of the tube into the insertion
aperture and slide the tube all the way down into the
well so that it seats in the recess at the bottom of the
well.
Load up to eight tubes in this way. The unit may be
operated safely with one or more tube locations empty.
Turning on
The back of the power supply carries the power input
socket, the fuse, and the on/off switch.
Insert the output connector of the wall mount power
supply into the main power supply input socket.
Insert the wall mount power supply into a 110 V AC
electrical outlet.
Tube in place
Power Supply - back
Switch Fuse Power in
