54
JOB FUNCTIONS
15.6
End nozzles - FOR SYSTEMS WITH SELETRON, ONLY
"BUFFER ZONE" FUNCTION ENABLED
Some spraying jobs provide for zones called "Buffer zone", where spraying must be reduced or shut off.
Further to the nozzles usually used, it is necessary to install special nozzles (e.g.: ASJ AOC), able to reduce the spray or drift, as terminal nozzles on
boom. The connection procedure of "Buffer" nozzles is as follows:
Left "Buffer" nozzle (boom view from behind), 1st boom nozzle, 2nd boom nozzle, ---> Boom nozzle no., Right "Buffer" nozzle (boom view from behind).
Fig. 112
Buffer zone
Buffer zone
If this function is enabled under implement basic settings (
chap
possible to alternatively select standard or special nozzles.
Nozzle selection modes are variable (they vary based on the Auxiliary
Input connected to the VT). Following are some examples.
END NOZZLES:
CORRESPONDING ICON ON "HOME" SCREEN
Special nozzle
LEFT
ENABLED
Special nozzle
RIGHT
ENABLED
Special nozzle
LEFT
DISABLED
Special nozzle
RIGHT
DISABLED
EXAMPLE OF NOZZLE SELECTION WITH SWITCH PANEL
• Activation of the left-hand special nozzle (when looking at the boom from behind)
Press switch once to the left to
activate the left-hand nozzle for
"Buffer zone" and close the standard
nozzle. The LH LED blinks.
• Activation of the right-hand special nozzle (when looking at the boom from behind)
Press switch once to the right to
activate the right-hand nozzle for
"Buffer zone" and close the standard
nozzle. The RH LED blinks.
• Deactivation of the left-hand special nozzle (when looking at the boom from behind)
Press switch once to the right to
deactivate the left-hand nozzle for
"Buffer zone" and open the standard
nozzle. The LH LED stops blinking and
will stay on steadily.
• Deactivation of the right-hand special nozzle (when looking at the boom from behind)
Press switch once to the left to
deactivate the right-hand nozzle for
"Buffer zone" and open the standard
nozzle. The RH LED stops blinking
and will stay on steadily.
EXAMPLE OF NOZZLE SELECTION WITH JOYSTICK
Seq. 1 R
Seq. 2 L
Seq. 1 L
Seq. 2 R
The operation is similar to the one of the sequential switch panel just described.
The functions related to the activation of nozzles are in the "Main" page.
For all the details about use, refer to the instructions supplied with the joystick.
